loom relocation on 180sx?

[podge]

if your mechancially minded strip out the full loom outta the car weld up all the holes tat arent been used for wires anymore and make your own custom loom only going throught the bulk head at one point

or if time is an issue cable tie the wires up as far as possible and get some light thin steel and pop rivet it to the inside of the arch holding the wire up tats wats dne on my ps13

[thegosson]

i have it done on my s14 ill try get ya a pick later. but there is a bit cut ot between the bulk head and wheel arch and just goes through there.

some pics would be great thanks.

[bart]

get onto finbar...
his engine bay is the coolest ever

[Frankae86]

get onto finbar...
his engine bay is the coolest ever

Sure Finbar doesnt run wires!! he has a telepathic connection with his ecu

[thegosson]

who's this finbar you all speak so highly of?

[docco86]

yea ill ty get pics up but my phone is a piece of shit.

[Romo]

Off topic, but what actually went wrong when yours fucked up Romo?

off topic reply to your off topic question but the wiper stalk went dead, fuel pump went dead, lights stopped workin, wiper jets kept going until the tank was drained, stereo went mad and the air con wouldnt turn off

all happed at once on a fuking dual carrige way in meath during the snow too

[Estie]

same happend me there few weeks ago! wipers started goin mental!

cars away gettin a new loom in now!

[Prodrifter86]

GO ON THE GOSSON BOI!!!!!!!

em i think shane you shud run solar power!
ah no on a serious note you shud check some other out some other forums and see does any1 have a project thread with this in it

[serious tom]

My Hazards work, but indicators and fron lights do not... (right stalk) anyone any ideas on how to sort it?