after punchestown i had a look around the car, just a general check over and discovered that the loom in the diver side front arch is getting rubbed by the wheel. iv been keeping an eye on this and never had a problem with it, but it must have been the fact that any other track iv been on were all right hand turns and punchestown had a lot of left handers. so i need to do something about this before i take the car out again and really cause some damage.
I'd heard that this is common problem with s-body drift cars so when i was first building the car id did this


which worked but its actually where the loom runs at the other side of the wheel arch (closest to the door) if you get me, where its rubbing.
I'm about to undergo the task of relocating the loom, so has anyone got any suggestions or have seen how others have done it and where is best to run the loom etc......?