Daily MX-5

[JohnRaff]

Not much of an update, Got the coilovers in, rolled the two front wings, have the front of the car sitting almost how i want it.


All that is left to do is roll the rear wings, set the ride height, paint calipers and hub rings black then its ready for paint

[Kruizer]

Looks good mate, no sure about the red cap in the centre though...

[JohnRaff]

Looks good mate, no sure about the red cap in the centre though...

As mentioned above it was painted red by the previous owner, i am going to paint them and the calipers black
Thanks

[Kruizer]

It has all the right parts fella, great job...

[raff]

its bad when your younger brother is making ya look bad ive had a project going for years and he starts one and is nearly there all ready, i just have to get mine aligned and its ready though, only trying to get that done for the last three months...
this is going to be a sweet little car when its done, cant wait for a spin

[Simon]

Thisis Epic... good job dude..

[JayoM]

Looking very, very cool! Nice job rolling the arches, should have got you to roll mine before sending it in for paint.

[JohnRaff]

Thisis Epic... good job dude..

Cheers man, and jay the wings are not rolled very well, but they will do.

Have the car almost done now, have all four wings rolled and have it sitting respectfully, went for a spin. No rubbing so all is well!
Will post a pic of it tomorrow as I'm on my phone now.
It looks good and I'm delighted so far, it goes to Tom Lawlor on Friday for its respray!
Happy days

[JohnRaff]

This is how it sits now ready to go for paint. I am happy I know its not That low but its low enough for me to drive fast on my country roads without rubbing.

[JayoM]

Sitting well! Lower than my 3 anyway, and that still rubs on some of the roads around here That's mainly due to the crossmember sitting well below the actual body of the car, genius!

What colour are you going for? Looks like 40 hades of grey at the minute haha.