Ali-d1936's S15 Spec-R

[S14a johno]

Agree with paddy it will look like a be Beatle
Go over fenders, they 17 al??
Also Canada new year?

[ali-d1936]

There's some kinda archs on my own s15 that arnt full over fenders there moulded on came in that way from Japan..

Dont do that anyways they look shit

Agree with paddy it will look like a be Beatle
Go over fenders, they 17 al??
Also Canada new year?

as paddy and john said them arches really are not my cup of tea but thats a nice s15 all the same.

na 18's bud, dunno about canada i think ill go back to OZ for my second year dunno where to go tho the woman is in perth but the lads are up in Darwin, decisions decisions humm, how long ya thinking of going for or where about?

dose anyone know if i can cut the overs along this line marked in pencil?

if i push it into place it warps around in a few diffrent places? but if i cut it and pin it down below it looks alot better.

so cut out and pulled them a extra 25mm, trying to get the angle of the slope right,


think ill go with this, so just get a peice of perspex now and warp it to the 3 points draw a line along it and i have my upper curve, cut that, fit brackets
and start fibreglassing

anyone have any tips???

[Kruizer]

Bring it closer to the tire

[ali-d1936]

Bring it closer to the tire

the top of the curve? when i took that photo it was 35mm above the cut, i let it down to 25mm now, have them all glassed up need a second layer then filler and start sanding

[ali-d1936]

fiberglass set from last night, offered it up STILL ALOT OF WORK left to do!!, another few layers of fiberglass start getting down to the basic shape, but its getting there.

front before i removed the bracket


rear


fitted




yeh? neh?

[paddyb01]

yeah i think it looks good

[ali-d1936]

yeah i think it looks good

Thats a relief to hear haha
Have to Cut the driver side one again dont know what happened at some point after i left them to sit the front of the driver side arch fell in a bit and it looks shit the only way to fix it is Cut pull it out and glass it again Wish i noticed before i put a layer on the back of it >
It was only after i posted the photos above i noticed, you can See it in the pics


Is there any other way to do this kind of pull before i spend a shit load of time on it?