Sorry folks that I haven't posted any updates in a while but hope to change that very soon. At the moment the car is in TDP having the Brembo's fitted however this in itself has been a task, the calipers are so big that it would have affected the lock on the car if I was to space them back from the wheel to allow fitment without a spacer. Being a double wish bone set up has its challenges and this is certainly one with big brakes. The stock position of the caliper was to remain however this now meant spacing of the Work Meister in order to clear the rear of the spoke. The space needed ? 55mm or just over 2" inches, now in turn this will have a knock on a effect where by I will more than likely have to do some modification to the footwell but sure thats only a cutting dish and a welder Lastly it looks like the car will be really wide already running an 18 x 11JJ up front and now a 55mm spacer on top of that, should make for some interesting arch work coupled with the 13.5JJ rears the car should have some presence, next up back to Mr. Stones for some more fab work...