MG Crash Repairs S15 RB26DET Drift car built by TDP.ie

[1jsoarer]

i presume the front end isnt finished??...theres no cross member in the front with the way the engine mounts are built!!.... hows the suspension and wishbones work, strength etc?

[robbie@tdp.ie]

i presume the front end isnt finished??...theres no cross member in the front with the way the engine mounts are built!!.... hows the suspension and wishbones work, strength etc?

Look very carefully at the photos you will see just how strong the mounts and chassis are. There will be a cross member and some trick drift steering setup allowing for the car to have no ackerman and massive lock. It will not have the normal tension rods but will use compression struts.

Robbie

[peterhouze]

can this still be called an s15
serious work gone into that and your only started on it cant wait to see the end result

[dR Dan]

can this still be called an s15
serious work gone into that and your only started on it cant wait to see the end result

I suppose it can

[billybgt130]

f**k me there is some serious work going in there,
some tasty work being done,

[yowdy]

this is nothing short of epic

[Stonie]

I thought it was removing betwwen suspension points is not allowed?

Anyways silly rule really cas its bend fairly handy...

Ridiculous quality of work...

Not sure about all the bars but none the less ridiculous.

Every bar in the car has it's purpose dude,, not easy to see exactly how the design works from the pics but every bar is relevant,,,

[Prodrifter86]

jesus fuking christ!!!!!!!!............. what a machine.

[dR Dan]

Every bar in the car has it's purpose dude,, not easy to see exactly how the design works from the pics but every bar is relevant,,,

I no... I remember reading it on Jays build i think... I would love to no ewactly what each bar is for but dats a tale for a beer mat and a biro over beverage...

I was always under the impression u cant cut out a floor doe...

[Stonie]

I no... I remember reading it on Jays build i think... I would love to no ewactly what each bar is for but dats a tale for a beer mat and a biro over beverage...

I was always under the impression u cant cut out a floor doe...

It's a different world when your going into the kinda detail to chassis strength that is going into this build,,, you'd be fairly drunk by the end,,, ha ha

The floor is only light steel and the front and rear chassis legs are still totally intact, so by replacing the floor with light steel and some bracing to make it stronger and safer,, I don't see why it should be a problem since putting a new tunnel in a car would fall under the same modification,,