Paul McCarthy's Barrysmotorsport M3 2011

[oldskooler]

thats serious twine for a clutch lads, then again its all needed for the wingnut behind the wheel!!

[MarkoC]

Question here, how these widened arches are made, from plastic ?
Where can i get them or what solution is used on that beemer ?

Cheers

[pmc-drifter]

Question here, how these widened arches are made, from plastic ?
Where can i get them or what solution is used on that beemer ?

Cheers

The rear arches are fiberglass CBY arches got from driftkits.eu, front arches are the same as them JUN style ones for s13's...

[pmc-drifter]

Long time since their was any update on this thread. Seen as how john is giving me a sponsored drive in this car for the 2011 season I will be updating it in the next few weeks, I have to sort out the back of it after the last round of prodrift in fermoy when john "tapped" the wall again, that fermoy wall loves him!! Other than that she is good to go again, will prob do a few other bits to it before the start of the season.

[kouki_kid]

Hope your gettin the finger out up dere we need all the cars we can get
For the FTW haha!!!

[pmc-drifter]

Hope your gettin the finger out up dere we need all the cars we can get
For the FTW haha!!!

The finger is out alright but all the concentration is on the new machine to get her done. Dont worry this machine will be rocking the wall in 2011 too