removing bushings???

[pigeon316]

whats the easiest way to remove old bushings to be replaced with pollys????

[FMD]

burn them out, is easiest way

[s15_spec_r]

as already said BURN THEM

[BoyRacer_X]

As said by the lads burn them....but if your in a rush drill through them before you burn them, they they come out pretty quick lad.

[phils13]

a good sledge and a socket it will take you half the time

[s15_spec_r]

a good sledge and a socket it will take you half the time

not really, could be wedged in it lad, would take a good press to get them out sometimes, a galvanised bucket with a bit of paper and petrol and bobs yer uncle. 5 mins and i had them burnt out, sledge would be alot kore awkward

[pigeon316]

how can ya hold it if usin the sledge?

just use a gas torch?

[way2fastforu]

how can ya hold it if usin the sledge?

just use a gas torch?

nevermind the sledge its a waste of time!!

gas torch be the finest or a bucket wit some old papers an a bit petrol.

dependin on the poly bushes you get you'll have to cut the old shells out wit a hacksaw too

[pigeon316]

i got the drift works ones. do they need the shels removed?

[way2fastforu]

ya the driftworks ones need the shells removed...iv the same one in my s13 an find them very good