As above, whats the best way to take doble sided tape off bodywork.
Dont wanna have to repaint the boot door after like.
Cheers
Printable View
As above, whats the best way to take doble sided tape off bodywork.
Dont wanna have to repaint the boot door after like.
Cheers
Peal off the other stuff, as much as you can...then use Tar and Glue remover, serious tack :)
heat gun and peel it off slowly ;)
Hammer and chisel ;)
rough man 9inch angle grinder with a wire brush!! hahaQuote:
Originally Posted by Stevo
if you no any pannel beaters man one of them may have a toffe wheel, they will no what it is!! small rubber wheel that goes in a drill its made of some fancy shit that doesnt harm the paint but eats the tape!! great fucking yoke!!
Tar and glue remover why didnt i think of that?:oQuote:
Originally Posted by Chuck_g
Iv that autoglym tar remover here, would that do the trick or what would be better:)
Ya will give it a go with the heat gun first to get as much as i can of it offQuote:
Originally Posted by Diesel-Dick
last resort:p lolQuote:
Originally Posted by Stevo
sounds like its sometn a magician has :DQuote:
Originally Posted by gem-s13
Quote:
Originally Posted by Stevo
fucking LOL!!!:DQuote:
Originally Posted by gem-s13
Ya there was a lad sayin something to me about a wheel kinda jobbie that goes on a drill allright, was just see'in if there was some way i could do it myself firstQuote:
Originally Posted by gem-s13
Iv the name of it now anyway:)
i used vinegar to take of the sticky shit from window tint, try that....did a serious job on tint
panel wipe is the job
Avery glue remover otherwise heat gun and roll it back till ya get it all of ;)
heat gun then small drop of petrol of a clean soft cloth
you'll never know it was there
holts tar remover, serious stuff
Toffee wheel is the only answer for removing tape left from mouldings and the sticky pads that hold numberplates on, then use panel wipe for any small bits that may be left on the bodywork. Make sure and keep moving the toffee wheel or YOU WILL burn the paint.
lets hope he gets it the right way around or the whole thing goes up in flames ha ha haQuote:
Originally Posted by lukeworx
Ha ha nope it all came off a treat ;)Quote:
Originally Posted by 20vees
aye panel wipe good job for that
Ye that the best way the rubber wheel on the drill and doesn't damage the paint
Petrol works a treat for getting sticky residue off.
as said rubber wheel on a drill and it will come off no bother
like this one here
http://solutions.3m.com/wps/portal/3...glNZ5R4RTPNBbl