Bit of advice welding......

he will be using a tig i would say tig would be no good

Quote:

---

Originally Posted by keith_b

Needs to be as clean as fuck lad any paint,oil or dirt will make the welds porous. Use a mini grinder with a wire brush and clean it till it shines. Even if theres dirt on the other side when you burn through it will fuck up the weld.

---

Both sides must be cleaned like above and depending on where/what your welding wax or sealer could be between panels which causes major problems

Quote:

---

Originally Posted by onevia

he will be using a tig i would say tig would be no good

---

def not tig he using has to be a mig. If he hasn't done much weldin and he can use a tig id be very surprised and using a tig on a fairly low setting it would be hard to burn through.

sorry ment to say using a mig. tig just burn through far to easily unless gifted with one.

Nice one for the info lads yea using a mig........... I ran outta gas this evening so il get another bottle tomorrow and go at it..........Il take all your advice into account and hopefully it't turn out a lot better....... Thanks lads.......!