my s14 drift build

[coakley]

said id throw this one up, itl be a slow one as funds allow but iv wanted to give drifting a shot after having a few rwd road cars so after about two years of saying i wud here it is my soon to be drift car.. itl be a lot of work but its a great base and has potential.. if only i cud say the same about the driver!:D
http://sphotos-a.ak.fbcdn.net/hphotos-ak-ash4/c67.0.403.403/p403x403/250243_10152095165920072_520991669_n.jpg
http://sphotos-g.ak.fbcdn.net/hphotos-ak-prn1/s720x720/527067_473779069309500_995237974_n.jpg

shes basic enough..
spec is as follows:
low km blactop sr
stage 2 excedy
stainless manifold,elbow,downpipe and thrust exhaust
s15bb turbo
hks ssqv
adj tension rods
adj kyb shocks and springs
rays volk 17x8 and 17x9 wheels with ultralite spacers..


thats pretty much it.. good few changes to be made..

iv started work on it already and picked up a greddy fmic last week and fitted it..stripped the interior and trim..


plans are:
weld the diff if ratio is good if not swap out for decent ratio and weld that too..
fit seats and harness's
install hydraulic h/b
get coilovers

then do a few drift days to get started, plan on building it up over the winter to be ready for the 2013 drift season.. and tips and suggestions advice greatly appritiated! thanks steve!

[pt_y2k]

Jesus the trailers gone to complete shite...:D Well be good steve,keep at it!

[decobyrne106]

you have what looks to be a good shell to begin with! keep the bumpers too, if it's drifting plastic can be repaired waaaaayyyy easier than frp. keep it simple and strip the tits out of it ;)

[broad.sideways]

well wear steve and best of luck

[coakley]

right after a massive amount of effort i have all the sound deadining off the floor.. arms are bate from hammering!!

http://sphotos-d.ak.fbcdn.net/hphotos-ak-prn1/76881_475772112443529_1023172152_n.jpg
made up a template too for the dash switch pannel, buddy is making it up in alumimum tomorow!
http://sphotos-c.ak.fbcdn.net/hphotos-ak-snc6/c0.0.403.403/p403x403/283150_475766392444101_1018693071_n.jpg

going removing the diff tomorrow ready for weld..


major shift on with this now to be out for fermoy!

purchased a few bits!
http://sphotos-g.ak.fbcdn.net/hphotos-ak-ash4/s720x720/264164_475772002443540_1748594267_n.jpg

[Chuck_g]

Great base car lad......was such a waste looking out the window at her for so long :) Me and Noel are looking forward to seeing her getting wrecked around a track.......

In the words of Noel a few nights ago "atleast he is gonna make use of her and not hard park it down cahalanes like a fag" or something like that.......in his angry voice :P

[Maurice.]

Jesus the trailers gone to complete shite...:D Well be good steve,keep at it!


Leave my trailer out of this !!!!!:p

[coakley]

update:

right got to work on the diff and back subframe.. dropped the whole lot and got out the grinder with the wire brush!
http://sphotos-f.ak.fbcdn.net/hphotos-ak-snc6/229257_476847275669346_1993442392_n.jpg

an hour or so later she was all clean and painted..
http://sphotos-a.ak.fbcdn.net/hphotos-ak-ash4/183301_476819342338806_79168338_n.jpg

next was the diff and she wanted to be welded:
http://sphotos-h.ak.fbcdn.net/hphotos-ak-snc7/10467_476811542339586_1960496242_n.jpg

once that was done i painted it and cleaned the back casing cover..
http://sphotos-a.ak.fbcdn.net/hphotos-ak-snc6/228013_476810919006315_1289746852_n.jpg

next on the list is paint the inside of the car... more updates soon..

[coakley]

decided to leave painting the inside of the car for abit, more important things on the list..

got the switch board cut out and all the switches etc fitted, still needs to be wired..
http://sphotos-b.ak.fbcdn.net/hphotos-ak-prn1/75624_478977192123021_1998556626_n.jpg

http://sphotos-h.ak.fbcdn.net/hphotos-ak-ash4/384041_478977302123010_1923034554_n.jpg

relocated the battery into the boot..
http://sphotos-g.ak.fbcdn.net/hphotos-ak-ash3/548381_478976732123067_455885103_n.jpg

fitted my pull cord too..
http://sphotos-e.ak.fbcdn.net/hphotos-ak-snc6/246566_478976862123054_143055154_n.jpg

slowly stocking up on rubber....
http://sphotos-c.ak.fbcdn.net/hphotos-ak-prn1/541131_478977135456360_1906190385_n.jpg

fitted the fire extiguisher too...
http://sphotos-f.ak.fbcdn.net/hphotos-ak-ash4/387544_478977335456340_1273161904_n.jpg

thats about it for the moment.. starting to take shape, getting my hydro later so il plumb that over the weekend and fit my seat...

[SeanP100]

Well wear Steve! Nice tow straps! jesus them bonnet pins are fair cheep! :O