View Full Version : work meister s1 offset advice
Hey folks i am pretty much decided i want a set of work meister s1 alloys for my car a 97 fd3s rx7 in 17 or 18 inch was thinking around 9.5 wide for front and around 10.5 to 11.5 for rear and i want to have as much dish as possible on these obviciously i will have to roll arches ,dont want to have to go down the line of a wide arch kit want a flared arch look .does any one have any information or advice as to what offset i could run and what would be achievable in terms of wheel width?any advice really appreciated.
be ware if you are buying new ones there is different disk types as far as I know which will define the dish..I have 18x10.5 et 24 on an 0 DISK or something and they have more dish than other meisters I have see with much more negative offset..
Administrator
19-02-11, 22:50
Welcome along Sir!
Have a browse through this link and around that site for info
http://www.iputinwork.com/?s=rx7+fd
http://www.iputinwork.com/wp-content/uploads/2010/10/fd_s13p_blk_800.jpg
was think of the sizes shown here 18×9.5 F & 18×11.5 R, with a 235/40/18 F & 265/35/18 R must try find out a bit more info on offset though.:)
MCNSPORT.com
19-02-11, 23:36
Where are you from Denis?
If your local you can call and we can measure up offsets for you. We are the work wheel dealer for IRL
cheers for the advice lads darren will definately be in touch in the next few weeks i am fairly close just in limerick
Welcome along Denis, best of luck with Dizz's old 7, awesome car...
welcome Denis, hope your happy with the harnesses;)
I ended up going with a set of 18 x10 +22 for the fronts fit perfectly with the front wide arch feed type fenders I picked up ,in the rear I went for 18x10.5 -3 with these however I will need arches flared or even possibly metal arches welded on as wheel is about 1 3/4 inches out past standard arch want the flared look on my fd3s rx7 instead of overfenders any advice lads of who would you guys recommend to do this?
if there sticking out nearly 2 inches then you need overfenders
50mm overfenders with a small spacer :p
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.