work meister s1 offset advice

[Denis04]

Hey folks i am pretty much decided i want a set of work meister s1 alloys for my car a 97 fd3s rx7 in 17 or 18 inch was thinking around 9.5 wide for front and around 10.5 to 11.5 for rear and i want to have as much dish as possible on these obviciously i will have to roll arches ,dont want to have to go down the line of a wide arch kit want a flared arch look .does any one have any information or advice as to what offset i could run and what would be achievable in terms of wheel width?any advice really appreciated.

[jdmjimmy]

be ware if you are buying new ones there is different disk types as far as I know which will define the dish..I have 18x10.5 et 24 on an 0 DISK or something and they have more dish than other meisters I have see with much more negative offset..

[Administrator]

Welcome along Sir!

Have a browse through this link and around that site for info

http://www.iputinwork.com/?s=rx7+fd

[Denis04]

http://www.iputinwork.com/wp-content...3p_blk_800.jpg
was think of the sizes shown here 18×9.5 F & 18×11.5 R, with a 235/40/18 F & 265/35/18 R must try find out a bit more info on offset though.

[MCNSPORT.com]

Where are you from Denis?

If your local you can call and we can measure up offsets for you. We are the work wheel dealer for IRL

[Denis04]

cheers for the advice lads darren will definately be in touch in the next few weeks i am fairly close just in limerick

[Kruizer]

Welcome along Denis, best of luck with Dizz's old 7, awesome car...

[Micko]

welcome Denis, hope your happy with the harnesses

[Denis04]

I ended up going with a set of 18 x10 +22 for the fronts fit perfectly with the front wide arch feed type fenders I picked up ,in the rear I went for 18x10.5 -3 with these however I will need arches flared or even possibly metal arches welded on as wheel is about 1 3/4 inches out past standard arch want the flared look on my fd3s rx7 instead of overfenders any advice lads of who would you guys recommend to do this?

[leeK9]

if there sticking out nearly 2 inches then you need overfenders

50mm overfenders with a small spacer