Hydrualic Handbrake Fitting Guide

[1-JAY-Z]

Anyone want to share how to fit them? I have a fair idea. Pipe from the master back to the handbrake and then another pipe from the other hole of the hydro to a T piece and go to each brake then yea? I think this is the general jist of it but can someone go into more detail or more importantly tell me if im wrong, Seen as im getting a hands on feeling lately for the car id rather try do this myself than pay someone as I'd like to know anyway. Also is where can the copper piping be got can you use braided lines either? I want to know what way you bleed the system as ive seen some lads get into bother and I also want to be able to use the foot brake while pulling the handbrake I think this has been an issue the way some people fit them?

[way2fastforu]

your bang on wit fittin one line from master to wand an from wand to rear t piece
bleedin is easy enuf press the pedal few times to get pressure thro system then wen bleed press pedal like normal but jus as the pedal is bout half way down pull the wand as well jus keep doin it till its fully bled an you've good pressure in the pedal an wand

[200sx]

how i always done it was...the line running from the master cylynder 2 the back breaks seperate that from the back and run that into your handbrake as your feed in,then make up another line 2 go from your handbreak 2 the back wear you took out the first pipe and thats it...i always plumbed them in like that and never had a problem!!

[1-JAY-Z]

I presume the hole furthest back on the wand goes to the rear and the other to the master.

[Dennis Healy]

I presume the hole furthest back on the wand goes to the rear and the other to the master.

front on cylinder goes to rear brakes
rear on cylinder goes to master cylinder

[gem-s13]

I presume the hole furthest back on the wand goes to the rear and the other to the master.

no not on all cylinders just put ur finger over the hole and pull the handbrake back it will either suck ur finger or push it away! what make hydro is it all girling, k-sport, d2, driftworks, ones the front hole is the rear feed

[Stevo]

front on cylinder goes to rear brakes
rear on cylinder goes to master cylinder

Ahhhhh gud man always wondered that!!!!

[1-JAY-Z]

Its k-sport, Also what way do you connect it to the master?

[1-JAY-Z]

front on cylinder goes to rear brakes
rear on cylinder goes to master cylinder

Would that be for all brands of handbrake??

[way2fastforu]

Ahhhhh gud man always wondered that!!!!

ah sure i could told ya that dude

@ae86 20v its be for most brands not many other brands would use the other way