skyline rear hub Qs

[way2fastforu]

rite wat i wana know is will ps13 bearins fit onto skyline r33 gtst hubs wit brake shoe assembly???an will uk s13 rear discs work wit the brake shoes off the skyline or are they smaller drums than on skyline discs??hope that makes sense does in my head
thanks
Dara

[CillianS14a]

The bearings should be the same, but i'm not sure? Go with the skyline rear brake assembly anyways dara, much better than s13/s14 rear brakes. You'll need the handbrake cables from the r33 too. Don't bother witht the s13 rear discs the r33 will be bigger afaik.

Have a look on sxoc its prob been covered before, have a look at ths thread:

http://www.sxoc.com/vbb/showthread.p...ght=r33+brakes

[way2fastforu]

i knew i needed the r33 handbrake cables i can get hubs an cables wit out calipers or discs for 100 but the full handbrake assembly is there so good deal but jus wana know if uk s13 discs will fit over the skyline shoes for time bein so i can use my calipers an get them at later time...sick my hydro handbrake it unpredictable locks sometimes an sometimes it doesnt an iv bled it shit loads already

[drift student]

no the 13 discs wont fit over the shoes due to the 13 not having a shoe setup.
you'll have to use a skyline disc...

why not just forget shoes and run a hydralic handbrake?

[way2fastforu]

uk s13 200sx have a shoe set up!!an i have a hydro handbrake but dont find it reliable enuf

[Driftma]

uk s13 200sx have a shoe set up!!an i have a hydro handbrake but dont find it reliable enuf

Thats because your rear caliper are slitly siezed

[way2fastforu]

nope there not man i only put good ones into it couple wks ago an there no resisatance from them they workin 100%

[drift student]

is it single or twin pot your usin??

[way2fastforu]

single pot the standard calipers on ps13's....if i was usin twin pots it'd lock up every time

[drift student]

one of the lads here was usin single pot with a hydro but twas a fail...
wouldnt lock up....

would it not be easy'r to swap to twins?