New wheel studs

[s13 drifter]

Got new wheel studs there today.Took out the old ones and tried to squeeze in the new ones but no a hope of them goin in.The hole is about 12.3 mm and the new spline on the stud is 14.3 mm.Would ye recommend drilling the hole to a larger size?

[nick180sx]

theres a difference in the front and back studs,sure ya got the right ones?

[s13 drifter]

I hope so man!!its the back ones im replacing.there the ones lorcan from drift 2 motorsport is selling

[Seamie tc]

have 2 sizes of studs here can send you down the smaller ones if you want.
tel 086 321 7687.

[Newsome]

I hope so man!!its the back ones im replacing.there the ones lorcan from drift 2 motorsport is selling

Fronts are biger man. Most likely a set of fronts you have.

[s13 drifter]

have 2 sizes of studs here can send you down the smaller ones if you want.
tel 086 321 7687.

what length are they?And how much?

[s13 drifter]

Thanks to seamie got my new studs yesterday.Quick question tho.would it be safe to use an impact gun to pull them through?I have about 4-5 mm to go untill there fully seated its near impossible with a wheel brace and 4ft extention!any other ideas?was told by two mechanics today to take off the hubs n just bate m through.wat ye all think??