help me please me heads wrecked!!!

[davemc-s13]

rite story is a blew me diff 4 months ago..

since im outa work iv been scrapin me pennys and i got more cusco internals perfect crown wheel an all and then i got a casing of andy with a good pinnion..

got it all put together tonite was delighted couldn wait to drive de car and as soon as i went down the road all i can hear in each gear is a loud whining noise

wats wrong with it would any 1 no im hoping its someting stupid otherwise im back were im started..

any1 no wat the problem is or could any1 on here fix it??????????

thanks

[gem-s13]

who built it back up for u?

[Jay Rockett]

Who put it together for ya? Was the backlash setup?

Is the whining defo coming from the diff, can ya hear any difference in noise when you accelerate and let off, i.e creating different loads on the diff..

[davemc-s13]

who built it back up for u?

1a the lads i no.. like whats after goin wrong is what wondering

[davemc-s13]

Who put it together for ya? Was the backlash setup?

Is the whining defo coming from the diff, can ya hear any difference in noise when you accelerate and let off, i.e creating different loads on the diff..

1a the lads he said he done the backlash.. yeah jay like if i feather the revs is quiter??

[gem-s13]

can be a few things lad either the back lash is set to loose or tight and the crown wheel and pinyon are not meshing right or a bearing is gone or on the way out did u put in new bearings or use the old ones?

[davemc-s13]

can be a few things lad either the back lash is set to loose or tight and the crown wheel and pinyon are not meshing right or a bearing is gone or on the way out did u put in new bearings or use the old ones?

would i have damaged it? like could it be takinm apart and put right.. i put all new bearings in 30209j i tink was the code for them

[gem-s13]

it depends whats up lad was it hard to turn when u were puttin it back in

[davemc-s13]

when he had it all in the casing it was spinning not a bother and the pinnion and crown wheels meshed up coz i remember him pointing dat out to me

[yowdy]

ah man u serously have no luck,,sounds to me like the diff isnt sitting rite in the case if you put new bearings on the diff