door closing 180sx

[johnbro]

Anyone ever have a problem with a door closing on a 180sx
The passenger door on mine has to be really slammed shut to close
There has been damage on that side but the door lines up fairly good and I've adjusted it in every way possible.

The problem is the window glass it hits off the panel thet it's supposed to slot into and the window doesn't slot in. that panel has no adjustment afaik.
When the window is down it will close fine???

[gem-s13]

Anyone ever have a problem with a door closing on a 180sx
The passenger door on mine has to be really slammed shut to close
There has been damage on that side but the door lines up fairly good and I've adjusted it in every way possible.

The problem is the window glass it hits off the panel thet it's supposed to slot into and the window doesn't slot in. that panel has no adjustment afaik.
When the window is down it will close fine???

there is adjustment every way on the window take off the door card and you will see 2 goldy looking 12mm nuts at the top of the door with flat screw heads in the middle of them and the same at the bottom of the door they move the angle of the window in and out and bang smack in the middle of the door is 2 10mm nuts these adjust the angle the window sits at when going up and down and then up the top again there is 2 more 12mm bolts at the front and rear of the door these are the stoppers to keep the window going to far up when you have it sitting in the right spot

[Keli]

You have to slam mine quite hard but I don't think there's anything particularly wrong with them

[Greg]

Your doors need new pins Keli.

[Keli]

Your doors need new pins Keli.

I stand corrected

[SUPER 180]

same with my passo door...

just giv it a good kick and she will close no bother

[johnbro]

thanks guys i think gems hit the nail on the head though.
If the window doesn't go up as far the door would close fine.
I'll try this later
One less thing to worry about.

[Scamper]

@greg - i got the pins for a tenner and changed them myself, handy job and makes some difference

[Keli]

@greg - i got the pins for a tenner and changed them myself, handy job and makes some difference

why are you telling greg?

[Scamper]

Haha sorry i misread that keli, i though he had said it! Ya can get them off Kieran(ks652) On INOC for cheap he'll post them too.