Viscous fan, leave in or bin???

[twailbait]

I meant that if its fucked then bolting it up will make it better.and i don't think having it bolted up would have done that?i'v had bolted one's on a road car and on a track car with no trouble. But a good condition unbolted one is the job,the more you rev the nuts off it,the more cool air its getting!

[GTSr32]

mmm may as well keep mine then!!!

[pole drift]

dont have the cowling anymore, it saw the inside of a skip a few months ago

[Stevo]

dont have the cowling anymore, it saw the inside of a skip a few months ago

Buy one

[Prodrifter86]

dont have the cowling anymore, it saw the inside of a skip a few months ago

cowling is what will stop the car from over heating . that was a big boo boo throwing it out. it seriously helps

[twailbait]

dont have the cowling anymore, it saw the inside of a skip a few months ago

Silly mistake.

cowling is what will stop the car from over heating . that was a big boo boo throwing it out. it seriously helps

Yep, I'd defo get another one, it will help 100%

[tweek]

Keep the viscous. I swapped mine for 2 electric fans and normal water temps went up over 10deg and oil 8deg. Pulled them off and went back to viscous after 1 drive.
Remember the viscous needs the cowling to do it's job properly, way too many lads run them without for god knows what reason

Hey leave me out of this lol

[Duck Drift]

what water temps do people see when on the track, i have oil cooler, 50mm rad, viscus fan with coweling in place+ a/c fan wired to a switch and still over 150degrees after a lap or two

[pole drift]

fuck a duck!!! what oil do you use??

[Duck Drift]

no problem with oil temps never goes past 90, just water reading off the top hose