GT2860r now fitted, but wont run properly!!

[colm]

Would lamda sensors/plugs have an effect?? Is it not jus for emissions??

standard ecu uses the lamda sensor to adust fueling for the entire map.

double check all your vacuum lines and wiring going to afm

[git]

how'd ya get on young man !

[Conor sr_20]

how'd ya get on young man !

All should be sorted 2moro..
Fingers crossed

[ian g sr20]

All should be sorted 2moro..
Fingers crossed

y wat did u find?

[Conor sr_20]

Only coped it yesterday..
The red emissions/Cat light on the dash is on..
So defo somethin to do with 02 sensor, maybe damaged wire or not re fitted properly..
So should be sorted

[Conor sr_20]

Thanks for all the info lads..
Got it sorted, the sensor in the cat was damaged..

[alan opel]

Thanks for all the info lads..
Got it sorted, the sensor in the cat was damaged..

do you have a cat or decat? thaut that sensor didnt mater a fuck!

[git]

do you have a cat or decat? thaut that sensor didnt mater a fuck!

me too thought it was a dash light etc etc

[Conor sr_20]

Yeah its a decat..
And don't think it does matter but when its plugged in the car is still hunting, as soon as you dis connect block connector.. Car runs perfectly!
Is it safe to jus leave it disconnected??

[way2fastforu]

ya its safe to leave that block connecter for the cat sensor disconnected..all its there for is if the cat gets blocked or get too hot it'll bring the light up on the dash...you could take the sensor out altogther seen as you've a decat an jus block up the hole wit a bolt an bit of exhaust paste