GT2860r now fitted, but wont run properly!!

[Dunnedriftin]

He can boost a bar with a standard map on that turbo, reving it to 2k wont even bring in the boost.

Thats what iv learned for today so!

[Conor sr_20]

jaysus man you got al your lines plumbed back ok ??

All lines checked.. All ok..

[git]

jees conor , did you by any slight chance disturb anything else or forget something real simple just a thought

[Conor sr_20]

As far as i know.. I didn't forget anything chris, don't no what it is??
It has to be something simply, because the car drives perfectly and only on tick over when you leave for 10-15 min's, then it starts hunting..!
Would it have anything to do with the s15 actuator??

[git]

emm doubt it sure thats just a controller if ya get me ?maybe im wrong what about lamda sensors plugs etc etc ? tweak of the idle control valve no

[S14a johno]

can you put the old actuator on? i have a brand new one here ya can try if that helps. took it of the 2871r
like i say it the actor, i though it would be a map,
but rob correct me there, just it seems be the only ting

[AEf20c]

Did you plug the o2 sensor on the elbow back in or damage the wires?

[Conor sr_20]

emm doubt it sure thats just a controller if ya get me ?maybe im wrong what about lamda sensors plugs etc etc ? tweak of the idle control valve no

Yeah i understand.
Would lamda sensors/plugs have an effect?? Is it not jus for emissions??
Adjusting the idle control, didn't help tried a few times!

[Conor sr_20]

Did you plug the o2 sensor on the elbow back in or damage the wires?

Yeah plugged it back in..
Could be possible that 1 of the wires got damaged..

[tweek]

sounds like unmetered air is getting in to the system i.e lines or pipework not connected properly or a leak in them.is the elephant trunk connected properly??pipework from the afm to the turbo.

sr20 afm will be grand for that turbo up to one bar.don't bother with a z32 afm for that turbo a rb25 one will be plenty big for that turbo and more than half the cost if you are going up grading