Best way to bleed brakes with hydro

[Bobbys14]

As above have a hydro in and i can't get good pressure on the peddle i have a brake bleeding tool the one thet preasureises the brake fluid, do i need to bleed the cyclinders and whats the best way any help welcome,

Thanks in advance..

[damo86]

get it up on stands and keep bleedin it takes hours the bastard, cooont of a job

[Bobbys14]

Do i bother with the cyclinders or just keep bleeding the callipers?

I'v noticed if i press the brake pull the hydro hand brake just a tiny bit without it engageing it will keep good pressure!

[2tonne]

if you have some pressure, bleed the cylinders first, does your hydro have a bleed nipple?

[Bobbys14]

No dosent have a bleed nipple,

how will i bleed the cyclinder? do i open the inlet or out let?

Should i bleed the master cyclinder too and how??

[2tonne]

nice guide here...
http://www.driftworks.com/forum/tech...rtesy-mjg.html

[Bobbys14]

Cheers i'll give it a go, any other tips from anyone that has blead there brakes with a hydro fitted?

[way2fastforu]

way i done it was bleed the brake pedal till you get decent flow of fluid out the bleed nipples then press the brake down an as soon as its down pull the handbrake wile the pedal is still down...keep doin this until ya get good pressure in both an job done

[Bobbys14]

way i done it was bleed the brake pedal till you get decent flow of fluid out the bleed nipples then press the brake down an as soon as its down pull the handbrake wile the pedal is still down...keep doin this until ya get good pressure in both an job done

Do i keep the pedal down and bleed the hand brake as you would the pedal?

[way2fastforu]

ya basically you press the pedal an as soon as its fully pressed you pull the hydro wand fully all wile keepin the pedal pressed until the bleed nipple on the caliper is closed then jus let the two of them go