Been a member on here long enough said I'd finally put up a build tread of my Kouki 180 road project, baught it about 3 mounts ago as a rolling she'll with the interior and all standerd suspension in it
Plans for it are full Kouki kit standerd silver and a set of bronze work xt7's (hopefully)
Current spec is

**suspension**

Apex coilovers
Adjustable Camber arms
Jap speed Adjustable Traction arms
Kabber performance Adjustable Rear toe arms
Driftworks geomaster 2 front hubs
Tein front castor arms
Extended flca
Tein hardened tie rods
Driftworks rack spacers
Solid steering bushing
Tdp rear subframe bushings

**Breaks**


Skyline front and rear breaks
Driftworks braded break lines
Standard hand break modified into hydro (work in progress)

**engine and gearbox**
Exedy paddle clutch
Oil catch can
Garret gt2871r with braided lines
Hks adjustable actuator
4 branch manifold
3 inch down pipe with flexi
555cc nismo injectors
Z32afm
Modified greedy sr to z32 intake pipe
Nistune Ecu
Isis fuel rail adapter for external fpr
Nismo fuel pressure reg
Walbro 255lph pump
Engine bay wire tucked
Cosworth headgasket
Front mount with custom piping
Japspeed 50mm rad
3inch exhaust from turbo back with shotgun pipes

**exterior**
Kouki rear lights with centre piece
Kouki side skirts
Rear bumper with Kouki spats
Fibreglass 3 piece Kouki front bumper
Steel wings
Rare Silvia 3rd break light
Rear arches flared

**interior**
Kouki front seats
Kouki rear seats
Full boot interior
Hks electronic boost controller


As she sat when I got it first,



Unfortanly the drift car had to be atripped to build this so stripped it down and put all the suspension onto the Kouki and got it sitting abit lower



Got it into the shed and stared dropping the engine into it





Got the front mount fitted and started mocking up the intercooler pipes



Just tacked them together and got one of the welders at work to weld them up nicer finish on them
Then what I could of done.





Me been fussy I didn't want any of the body loom in the engine bay so decided to put it in under the dash and extend out the wires for the lights and things. The mess I had ended up with. ( ended up allot tidyer after I changed how it was ran but got no pictures of it)




Put on all the kit for a quick look the inner child got the better of me





And the jdm coolness 3rd break light



This is about as far as I am at the moment, hopefully be going off to paint in the new year.
Il try update this in a few days with better/more pictures