skyline drift and track car

[podge]

I taught the injectors were 560cc
What was the fuel pressure set to ?
What turbo are you running ?

they r im running e85 it uses a nice bit more fuel
fuel pressure was set to 3 bar and rising as the revs increase i think
wheni bought the car i was told it was a 2530 but john did work on it for the prvious owner and he thinks it is a hks gtrs
it was also a dyno dynamics rolling road i was on which r meant to be quiet hard to make good power on was told if it was tried on other rolling roads it would make more power

[Cooldrft]

The figures look high for a 2530 on 0.7bar alright .
Could you have upped the fuel pressure to 3.5-4bar ?
Are you going to mondello saturday ?

[podge]

The figures look high for a 2530 on 0.7bar alright .
Could you have upped the fuel pressure to 3.5-4bar ?
Are you going to mondello saturday ?

seema bit high for the low boost alright
they could of had i suppose im not to sure im not tat up on tat end of thingsit runs and im happy wit it at the min ill get thousand cc injectors when money allows again and run it on a higher boost then
i havent booked it yet gonna try in the morning and see if theres spots left heard its full thouso ill probably just head up to stones

[podge]

righto loads a work to be done before the weekend for prodrift after blowing loads a boost pipes the weekend all new boost pipes and connectors r being build tis week also as the manifold flange is all warped im changing tat to an apexi one i have here and also going fitting an external wastegate for more noises
so loads a be done will get pics during the week

[Greg]

Get the finger out.

[podge]

Get the finger out.

shush u ya doing fri

[Greg]

shush u ya doing fri

Nope. I have no cage or harness. I'll go halves with you and drive your car.

[podge]

aw no thanks greg

things is looking up pipe from intercooler to inlet manifold is made and ready to be fitted
apexi manifold has the new t3 flange made up and welded on
forward facing lights put on and wired not the greatest looking but hey cant be helped wit the way ive the intercooler installed
all ive left to do now is make new down pipe new exhaust to intercooler pipe buff it get the stickers on thursday and check the map on it looking good for fri at last

[podge]

well cars not gonna be out for prodrift the weekend:mad)

on the other hand heres a few pics a the work done over the last few days

apexi rx6 manifold wit t3 flange fitted and welded on cant get over the thickness of the steel in it not like your ebay crap manifolds hopefully tis wont crack or break off




new stainless stell intake pipes and dump valve fitted hopefully no more boost pipes blowing of or leaking






and final pic a teaser of the graphics will put up more pics soon when ive the rest of the kit put back on

[wezwkd]

No sign of you today Ted. Will you be up tomorrow. ?