loom relocation on 180sx?

[thegosson]

after punchestown i had a look around the car, just a general check over and discovered that the loom in the diver side front arch is getting rubbed by the wheel. iv been keeping an eye on this and never had a problem with it, but it must have been the fact that any other track iv been on were all right hand turns and punchestown had a lot of left handers. so i need to do something about this before i take the car out again and really cause some damage.
I'd heard that this is common problem with s-body drift cars so when i was first building the car id did this


which worked but its actually where the loom runs at the other side of the wheel arch (closest to the door) if you get me, where its rubbing.
I'm about to undergo the task of relocating the loom, so has anyone got any suggestions or have seen how others have done it and where is best to run the loom etc......?

[nicko]

doing the same thing myself ill put up pic off what im doing am removing some off the unused wirs in the loom to. tricky but as well to do it now

[thegosson]

doing the same thing myself ill put up pic off what im doing am removing some off the unused wirs in the loom to. tricky but as well to do it now

good man, any advice or tips welcome...

[way2fastforu]

have the same prob wit my driver wheel rubbin the loom too where it comes out the foot well an into the arch...only jus touches the tape round the wires still annoyin wana move mine as well

[nicko]

ihave been looking in to having only one entry point back into the car away from heat etc. its working out ok because making everything independ. all going to be heat rapped to had prob with melting before haha

[thegosson]

anybody els have a good way of doing this before i attack it?

[docco86]

i have it done on my s14 ill try get ya a pick later. but there is a bit cut ot between the bulk head and wheel arch and just goes through there.

[Romo]

it's a cunt when it rubs through, my electrics are still acting up after they all got mashed together...

try tuck it up to fuk like this
http://www.180sx.co.uk/resources/gui...om-relocation/

[Administrator]

Off topic, but what actually went wrong when yours fucked up Romo?

[Prodrifter86]

shane id say just keep going right handed and dont look back!
haha nah best of luck with this one batman!