sound deadening

[podge]

any easy way to get tis off ive used chisels screw drivers some sort of spray and release stuff i was told worked as well freezes it or something heads wrecked trying to get it off

[s13-ste]

best iv heard is the freeze spay and a sharp chisel and mallet, its just a pig of a job to do

[Barry]

Andy just used a sharp chisel and lump hammer as far as i know.

[barryl]

hammer ,chisel and heat gun and lots off patience

[Barry]

hammer ,chisel and heat gun and lots off patience

Lots and lots of that needed

[Administrator]

Do it on a cold fucker of a morning too. Helps the stuff come off in pieces rather than chunks of soft tar type shite. I used a mallet, sharp wood chisel and some white spirits

[NIALL JZX]

dose of a job arite..
done mine was a fucker of a job. heat gun made it real sticky though, so gave up on that...
get off wat ya can wit hammer n chisel n den gettin one the spinny wire brush type heads for a drill n u'll get it mint..
looks a tidy job wen done. well worth doin it an sprayin the inside..

[podge]

dose of a job arite..
done mine was a fucker of a job. heat gun made it real sticky though, so gave up on that...
get off wat ya can wit hammer n chisel n den gettin one the spinny wire brush type heads for a drill n u'll get it mint..
looks a tidy job wen done. well worth doin it an sprayin the inside..

tats the plan planning on spraying it up to tidy it all up a bit and leave it neater looking

[mike g]

been there and done it and dont wanna do it again lol

[Dunnedriftin]

in the middle of doing my R32 at the moment, and it weighs quiet a bit!

hammer & sharp chiesl is the best and once all is romoved then a cloth & white spirits to clean it and a scraper to get the little bits!

might be tryin liquid nitrogen on the weekend tho as im able to get my hands on it