sound deadening

[Barry]

Andy just used a sharp chisel and lump hammer as far as i know.

[barryl]

hammer ,chisel and heat gun and lots off patience

[Barry]

hammer ,chisel and heat gun and lots off patience

Lots and lots of that needed

[Administrator]

Do it on a cold fucker of a morning too. Helps the stuff come off in pieces rather than chunks of soft tar type shite. I used a mallet, sharp wood chisel and some white spirits

[NIALL JZX]

dose of a job arite..
done mine was a fucker of a job. heat gun made it real sticky though, so gave up on that...
get off wat ya can wit hammer n chisel n den gettin one the spinny wire brush type heads for a drill n u'll get it mint..
looks a tidy job wen done. well worth doin it an sprayin the inside..

[podge]

dose of a job arite..
done mine was a fucker of a job. heat gun made it real sticky though, so gave up on that...
get off wat ya can wit hammer n chisel n den gettin one the spinny wire brush type heads for a drill n u'll get it mint..
looks a tidy job wen done. well worth doin it an sprayin the inside..

tats the plan planning on spraying it up to tidy it all up a bit and leave it neater looking

[mike g]

been there and done it and dont wanna do it again lol