Rear setup question

[Kruizer]

Story is I want to uprate the back end of the car so Carpo was telling me to fit an R33 GTR rear end to a 200sx subframe which will take the power. However I want to keep the pcd at 4 x 114.3 so will the drives from the gtr rear fit s13 hubs or will it just be a case of using spacers 5 x 114.3 to 4 x 114.3 ?

[Cooldrft]

You must be running serious power to need a gtr rear end

[gem-s13]

4 stud hubs will fit on and drives will fit in them but why??????? what power are you running?? unless uv got over 500bhp and brakeing stuff the whole time its pointless

[Kruizer]

@ Cooldrft : All going to plan, yes.

@ gem - s13 : So I could get a rear subframe from a uk s13 with 4 x 114.3 brakes, hubs and then fit the gtr diff and half shafts to it ?

[way2fastforu]

wat power are you makin????there no point fittin a gtr back end unless your makin serious power like gem said!!its only waste of money otherwise

[Kruizer]

I already answered that lad. Just looking for info on the rear end thanks.

[2tonne]

So I could get a rear subframe from a uk s13 with 4 x 114.3 brakes, hubs and then fit the gtr diff and half shafts to it ?

Exactly .

[Kruizer]

Thank you.

[gem-s13]

you could use the 200 stuff yes but if you are going to be running as much power as you recon id get a skyline brake setup and put it on and use your 4 stud bearings/hubs and redrill the discs to 4 stud you will stilll have a drum hand brake and 2pot rear calipers better job!!

[Kruizer]

Sounds good, subframe I'm looking to get in Ireland but the gtr gear will be coming from the uk so I want to know exactly what to order you see...