F.A.O. those of you with Bride Seats and 4/6pt Harnesses

[Fredericks Balls]

Sorry for the new thread, but if i bumped the other people wouldnt read after the stupid amount of time it took me to figure it out haha

Anyway Ive been looking around to find the best mounting point and I saw something on both sides of the seat. They kinda look like blanks covering a threaded hole maybe for eyebolts? I tried to take one off but if it is a threaded blank its tight, if its not i dont want to bend/damage it. Anyone else have a go at this?? All the other mount points seem a bit far forward for my liking to be honest

Thanks!!

[way2fastforu]

mount the lap part of the harness to the 2 back bolts on the floor that hold the seat down man its simplest way

[bart]

put hem in where ur seat belt goes lad....
one on side pillar... then other one on where seat belt clips into...
back ones into the same as the back seat belts go into

[Fredericks Balls]

mount the lap part of the harness to the 2 back bolts on the floor that hold the seat down man its simplest way

put hem in where ur seat belt goes lad....
one on side pillar... then other one on where seat belt clips into...
back ones into the same as the back seat belts go into

I think the floor ones might be the best, they are further back then both standard belt mounts. I was just curious if these were for belts as they would be further back again.