Polo's Team Green s14!

[Polo]

Im not going to start from the begining as its waaaaaaaaaaaaaaay to long, but here is the link to the full thread on Driftworks and SXOC

http://www.sxoc.com/vbb/showthread.php?t=309769

http://www.driftworks.com/forum/drif...t-up-spec.html

The spec of the car is huge and iv not done a full list in ages!

Il copy and paste the best bits from the two threads linked above and copy in all the bits from this years rebuild.

i got the car totaly stock, uk car in 06, after a few years it took on lost of suspension mods and power mods but stade looking standard-ish.
This was after a few years of practice, i built it for 08 comp year.

[Polo]

Done a few more bits,
Modified the door cards

and the dash



Made a metal chequered foot plate

Hahaha, 1st time iv looked at it from the back this far away!! WIDE!!!!!

Then made this(well all of it apart from the tig welding,got a mate to do that)


Then cut a hole in the bonnet, finished with a bit of rubber trim and the box below it. Can you figer out what it is yet?




Tidied up the loom and secured it



Thats it for now.

[Polo]

Pics
standard


My contraption! A bit more trial fitting and dummy fits.




Inside! No trumpets!!!None of that dead space and terbualance:euge:

ICV placing


New DE throttle boddy WITH cold fast idle

[Polo]

Chop chop


new slam panel and cooler in its new position


Manifold is all finished after nearly a year



moved the fuse box to make room for the throttle

zipped a few holes up


new slam panel welded in, was going to make it bolt in for easy engine changes but i hope not to be doing to many:wack:

chopped and modded the cooler end tanks to sute the set up

[Polo]

More done, im starting to think my driving skills will let down all my hard work this year!:wack:
New chunky rad fitted,

And made this, any ideas? Took alot longer than i had hoped but came out alot better than i had hoped too.












Propa BO init Dan:smokin:

[Polo]

[geordier1]

Love this car,has changed some amount over the trs,the colour scheme in the first couple of pics was cool...

[Polo]

All the Apex arms and coilovers fitted.





Friday

Today

I got all the rear end finished, brakes on and bled etc, temp alignment the lot, also got the front coilovers and tein rods and ends all fitted up, just got to do a bit more modding up front and fit the Apex castor arms, then wer good to go for graphics on tues.

[Polo]

sorry loads of pics but its :smokin:





Then i sorted all the waist gate jigery and flanges






Knocked up a new down pipe






Still loads to do but that was one nights work.
Oh the turbo is a custom GT30/76r from Owen Developments and the gait is a TiAL 44mm jobbie.

[Polo]

So, where i left, got a box of goodies from goodridge and made up all the oil and water feed pipes, then slaped on some heat sheild.



More heat protection, shortening of water pipes and moving breather pipe etc etc.


bit of heat wrap


After making up some more bits and bobs, spanky braided vacume pipes, IC pipe and modding one end tank on the IC it was time for the final fit.





Just got to sort out a few little running isses and get it mapped again an im good to go for teeside on friday.