So with mapping next week I'm in a panic to get it going again .. I'm a mechanic by trade and I work a lot in the evenings for myself so it does be very hard to find the time to get near it ..

Fitted my extra lock drift work steering boots . Fit really we'll and not even under stretch and I have a good lock set up ..









Since my car was hicas from factory I set upon removing all of it and while keeping the standard hicas power steering pump I disassembled it to remove the veins from the rear of the pump to stop it creating pressure . Gonna mig weld up the pipe fitting in work tomorrow



After hours upon hours of work I'm finally finished my exhaust manifold . It's now single scroll too . One of my mates is going to get it tig welded up for me at his work so I'll have it back at the weekend


Fitted my tomei fuel pressure regulator. My z32 Nissan fuel filter and made up a few braided line with all the earls an6 bits










Also went braided from the fuel pump to the hardline and fitted the fully reconditioned tank I got done .. Bridges the fuel pump relay and set the static pressure on the regulator to 37psi . 36psi is the standard recommendation I think






That's pretty much all for the moment . I'm waiting on post from frsport with a throttle body gasket and a idle air controll valve gasket . And a sr s14 throttle body pulley . All Genuine Nissan too . Them I can bolt on the inlet . It's only sitting there at the moment ..

The water lines to the iacv and the two water lines to the throttle body I've also made in braided line just waiting on some more an6 line finishers for them . Expensive but fuck it no price on reliability .. The hardship of a 23 year old water pipe leaking would Rot me ...


Trying to mock up the new intercooler pipe work . I really need to get new pipes made


Also done some coil over adjustment






Got my manifold back tig welded up so I can finally put it all back together now ..





Also got a new iacv gasket , throttle body gasket , s14 throttle body pulley to work the Freddy manifold . Oh and a bit and washer for the rocker cover ha