Adam's k's ps13

[batman026]

Very nice car and your making some excellent choices when it comes to mods etc. Keep up the good work.

[adam 9]

I went and looked at Spider-mans white one , was a great car just wasn't for me in the end .. So imported this .. .. Can't wait to get it finished .. Thanks


Jacki didn't spray it . I waited 3 months for him but was too busy so my local martin Dwyer done it and what a great job he done . Expensive but you pay for quality ..

[adam 9]

Very nice car and your making some excellent choices when it comes to mods etc. Keep up the good work.

Thanks a million . I'm going to be basically using all the tomei engine parts .. And mapped up on nistune hopefully around Xmas ..

[Stevo]

Looking good adam

[Ross.]

beautiful.

[adam 9]

Just a few more little bits . Feeding the tomei addiction .. So that's mostly the fueling sorted now . Got a z32 fuel filter too . Just gota mock them up and order the correct amount of -6an fuel line to do them in braided hoses






For those of ye who know tomei bits they don't make a gasket in 86mm bore

Also got a z32


My tidy sr to denso jumpers thanks to Stevo

[kenny046]

serious car looking forward to seeing more updates

[adam 9]

Yet again some more post ...

Got a nice polished tial sport external wastegaye . These are not cheap but quality is most important to me and my build ..

1 bar wastegate spring so that's the lowest it can be ran at .. I'll be running 1.3 bar high boost ..


Got some tomei rocker arm stoppers too

Also got a set of extra long inner tie rod boots for my extra lock off driftworks ..

[adam 9]

Small bit of shopping done with jdm distro ..

Got a 4.1 ratio cusco (model unknown) 2 way lsd ..



And I got myself a nice used but like new twin plated os giken clutch kit , flywheel and release bearing .. It's still in japan but on it's way . Gotta love the rattle of a twin plate ..





I'm nearly there . I need it mapped now but my preferred mapper is unreal hard to get on the phone ..

[adam 9]

Today's arrival



I can confirm to anyone looking for torques for the arp bolts
It's 90flbs in 3 equal stages ..