Said I might as well start a thread for this. This is my first project so it will probably be slow and painfull. The car is a rusty-roofed E30 4door with an m50b25 engine. I took it as a p/x for my old e36, this started as a road car but penalty points changed them plans. Don't have a huge budget as I'm still in college that's why things will be a bit slow for now and I've no shed either haha

So things I've done so far are:

- car came with bc coil overs and an e36 rack fitted
- stripped interior including the dash.
- beat out my heater motor with the hammer.
- stripped all the interior wiring loom and threw it in the bin.
- d2 racing hydro and new obp .625 cylinder.
-new disks and CL pads.
- sprayed the inside last night with the help of " Dermot-r32"
- got a Mishimoto rad (not fitted yet)
- ordered a 3 gallon fuel tank with built in swirl pot (on the way)
- had mike Deane build my 3.6 LSD

Plans to do:

- spray the outside
- fit the new rad and make up a frankenstine expansion bottle
- lower the car
- get extra lock
- fix the bumper after super drift
- fit the fuel tank and new lines
- flock the dash and wire the new fuel pump to a switch as well as a second fan and the lights etc
- refit the bucket seat and harness
- fit a new low temperature thermostat and a better (not leaking p/s pump)

Probably more just can't think ATM. Anyway hope to update this again shortly and any ideas comments appreciated, good or bad