manspec wheels on standard archs

[Deco84]

bought these wheels last week for the crack to see what they would be like on the car always wanted set so said fuck it
i want to stay away from overfenders if i can just wondering is it possible to roll/flare this much on a standard arch have been pming a few lads about it
any info appreciated
theres 25 mm spacers on the front of the car at the mo hadn got the socket to take them off ,there was 25mm spacers on the rear but got them off as they were diffrent to fronts
the car is also at nct height needs loads of low

the wheels are
18x10.5 et18
18x9 et25








inspiration

[D-turbo-lad]

they il fit !! run a 225/40 /18 on the rear any way !! small bit of rear camber and start rolling from there ! they will work ! just will take time to roll them out that bit . ya may need to paint the quarter's after ! but that depends on how good your arch's are and how good the man doin it is ! and run a 215/40/18 tyre the front and get a 15 mm spacer instead of the 25

[PeterT]

they will fit no problem! as soon as you start lowering it the wheel will gain more camber. get adjustable camber arms too and a smaller tyre and a tiny bit of a roll and itl fit no problem! the front you may need a spacer as the wheel might hit the calliper if you run it with no spacers

[ste]

Will look savage

[Simon]

For suuure ya will get them to fit, nooo bothers

[Deco84]

Nice one for the info lads wasn't sure had looked on zilvia an seen a few lads had it done with similar spec

[grange]

did you buy them of a lad in wicklow?

[Deco84]

Yeah man Dario sound lad altogether he's on here as far as I know

[grange]

Yeah my mate bought a s14 of him . I was goin to buy them of him. But forgot all about them. ohhhh well. They were cheap and look deadly.