Rx7 fc3s

[Simon]

Holy shit thats going to be wide. nice work on the arches man... did you do any porting on the engine or you going with some crazy turbo set up?

[Kruizer]

Told ya you could do it fella, did you cut the original arch ?

[s15richie]

Told ya you could do it fella, did you cut the original arch ?

Didn't think I would be able to but just had a try I cut out a few inches off the original arch forgot to add that in to the thread I primed the raw edge where I cut it then under sealed both wheel wells

[Kruizer]

Didn't think I would be able to but just had a try I cut out a few inches off the original arch forgot to add that in to the thread I primed the raw edge where I cut it then under sealed both wheel wells

good lad looking toward to seeing her done

[C-Rex]

Seeing all the FC threads being updated makes me regret crashing mine into an ESB pole

[jasonfc3]

savage man im keepin an eye on tis

[s15richie]

Well it's been a while since I put dated this so this is what I have been doing the past few months

id2000 injectors
ptp turbo blanket

new clutch


porting


starting assembling






fmic fitted
painting the bay before fitting the engine

ready to go in

ptp lava heat wrapped down pipe
adaptronic ecu and innovate wideband 02

[kevH]

nice build man what kind of power are you expecting?

[s15richie]

Holy shit thats going to be wide. nice work on the arches man... did you do any porting on the engine or you going with some crazy turbo set up?

Haha thanks man. I didn't get any porting work done yet but I will be soon