Rx7 fc3s

[flatout]

if ya make the car fit the wheels your going to have one cool lookng fc,

[C-Rex]

What wheels have you on your FC now Rory?

[Simon]

if ya make the car fit the wheels your going to have one cool lookng fc,

Rory did ya get my message the other day? send us on pics of them mirrors if ya get a chance. Sound

[raff]

should be cool if ya get her done,abd defo dont go for a smaller tire when inflated they dont even meet the edge of the rim, like i said go for a 305 or 315 next time,the 285 was atoo much of a stretch,, or thinking about it maybe its the sidewall is too low?

[s15richie]

Been flat out in work so not much progress but nearly there (I thought )
My new brake master cylinder

My new water pump

Out with the old one

Decided to clean up the housing before putting it back on

All cleaned up

Got my 50 mm over fenders still a bit small haha


Picked this up off Dave

I thought I finally had every thing sorted with the new water pump and thermostat I done a Champagne test and it failed :smt013 so I'm back to square one so I started stripping the engine back down
http://i1327.photobucket.com/albums/...psd501e214.mp4

[Kruizer]

Better off just chopping the overfender and remaking it....

[Simon]

much was the water pump out of interest? sorry to here the bad news..

[s15richie]

much was the water pump out of interest? sorry to here the bad news..

It was €130 all in man. Ah it's not to bad at least it's just the water seals pulled the engine out yesterday

[s15richie]

Better off just chopping the overfender and remaking it....

I wouldn't be able to do that man I would make a balls of it haha

[Kruizer]

I wouldn't be able to do that man I would make a balls of it haha

Any bodyshop worth their salt would be able to do it, could help out if you were closer...