My R32 4door track/drift project

[AndrewR32]

Got her into the garage over the weekend and managed to start the ripping this evening.

Front subframe and suspension off:

[AndrewR32]

Jesus....

6 months since an update? and doesnt look much different. although the garage corner isnt so tidy these days.

So far i've the following bought:

Engine:
RB25DET Spec 1
SARD FPR
Front mount intercooler
Toyo Oil Cooler with Relocation
55mm Alloy Rad
GTR Fuel Pump
3in stainless downpipe

Front Suspension:
R33 Subframe
R33 P/S Pump, rack, etc
R33 Tie Rods & Ends
Driftworks Camber Arms
Driftworks Tension Arms
Driftworks Lower Arms
MDU Coilovers
5 Stud Conversion
R32 GTR front brake setup
Completely polybushed
Driftworks braided clutch, hydro and brake lines

Rear Suspension:
Non Hicas Subframe
Driftworks Solid Subframe Bushes
Adjustable Camber Arms
Adjustable Caster Arms
Adjustable Toe Arms
5 Stud Conversion
MDU Coilovers
R32 GTR Rear Brakes
Hydraulic Handbrake
Completely polybushed
Driftworks braided hydro and brake lines

Electrics/Gadgets/etc:
Twin 12in elec fans
HKS EVC Boost Controller
HKS 52mm water temp gauge
HKS 60mm boost gauge
Loads of toggle switches, cut off switch, etc
Z32 ECU
Z32 AFM


Interior, etc:
Manual pedalbox conversion
Dished steering wheel, snap off kit and boss kit

Exterior:
Full Vertex Kit
Fibreglass Bonnet


How it was sitting before fitting coilovers (sitting on bilstein suspension)




I hope to get alot more done next week while on holidays

[Sir Diffsalot]

ya need to get this sorted and get driftin

[grange]

haha ye the back of the van was full with everything to finish this the last time we met

[Johnnyghia]

Any updates Andrew.

[grange]

who did you get your twin fans of andrew?

[AndrewR32]

ebays finest! about £50 for the pair + postage i think

you'll get twin 12s on an r32 alloy rad no problem. have it set up same on my road car

[AndrewR32]

not a whole pile unfortunately.

waiting on a pallet of parts to arrive from the uk.

have started piecing together the interior (interior fans) and going to start tackling the dash wiring over the weekend hopefully