welded e36 diff and lowering springs

[Darenm]

Need these gone asap need funds for sunday

Welded diff
Sparco lowering springs 30mm drop i think
80e for both
Or 50e each

[Lucius]

4 or 6pot?

[DaveM-sport]

What ratio is the diff Darren?

[Darenm]

What ratio is the diff Darren?

Was told 3.9 bit cant conform dave

[DaveM-sport]

Cool. If its a 3.9, I'll definitely take it as it'll save me making up a 4.3 I was planning on doing tonight for Sunday.

When your near it, could you check for me. Just count the number of turns the input shaft makes to one full turn of the output shafts.

It'll be 3.38, 3.45, 3.91, 4.1, 4.27 or 4.45.

More than likely it's a 3.38. Might take it either way as a spare anyway, just be handier if it was a short ratio to start with and save abit of time

[Darenm]

Cool. If its a 3.9, I'll definitely take it as it'll save me making up a 4.3 I was planning on doing tonight for Sunday.

When your near it, could you check for me. Just count the number of turns the input shaft makes to one full turn of the output shafts.

It'll be 3.38, 3.45, 3.91, 4.1, 4.27 or 4.45.

More than likely it's a 3.38. Might take it either way as a spare anyway, just be handier if it was a short ratio to start with and save abit of time

Just had a look there dave and il be honest dont have a clue lol if u wana check it urself il be round tomorrow

[jamielmbrd]

If dave doesn't take the diff I will, I'm looking for a spare one myself

[jamielmbrd]

Your pm inbox is full lad

[dermot-r32]

have someone for the diff too darren if everyone else decids not to buy it.ha.didnt no there was such a demand for them

[Darenm]

Rite lads need this gone asap first come first serve

Ring or txt me 0872823479