Japspeed full steering arms - info needed

[skinnynphats200]

I'm probably explaining this all wrong lads and confusing you and myself All I know is I need to get aftermarket tie rods with longer thread

[Jay Rockett]

The knuckles arnt done like your's Billy, they were designed to be used with bump-steer correction outer ends, like the Japspeed, KTS, TDP kits..

With minimal mod's this setup is giving the best results.. There wouldnt be a need for more rack travel if the knuckles were done slightly differently or if bump-steer correction outer ends are used!

Kyle just get the Tein rod's Gem has up there, or the likes of the Japseed things when ya can!

[skinnynphats200]

Thanks Jay was hoping you would post and explain Yup yup, will do

[Jay Rockett]

Thanks Jay was hoping you would post and explain Yup yup, will do

Nay bother, see ya tomorrow dude!

[Shane f]

The thread on the inside of the Japspeed tie rods is the same as the Tein's without their washer fitted . So the Japspeed rods have 6mm more thread into the rack then Tein's

[skinnynphats200]

The thread on the inside of the Japspeed tie rods is the same as the Tein's without their washer fitted . So the Japspeed rods have 6mm more thread into the rack then Tein's

So Japspeed rods have a 6mm longer thread into the rack for defintite yeah???
Cheers mate exactly what I was looking to find out

[Shane f]

Yup I designed them

[skinnynphats200]

Yup I designed them

Good work!