Project 328i - a lot to learn

[sideways-theonlyway]

did she bleed up ok for ya lad?
also drill a couple of 3mm holes on the inside if the thermostat to help the flow.

just after spending an hour at getting it bled properly this time hopefully, jacked her a way up on the passenger side so the fill and bleeder was at the highest point and a good bit of air came out of it so hopefully that's what the problem is.
I'll look into drilling too, tks, hadn,t heard of that

I've a spare water washer container and pump so was gonna install them and have a light spray of water going against the rad, would that be any addition?

[mickel]

just after spending an hour at getting it bled properly this time hopefully, jacked her a way up on the passenger side so the fill and bleeder was at the highest point and a good bit of air came out of it so hopefully that's what the problem is.
I'll look into drilling too, tks, hadn,t heard of that

I've a spare water washer container and pump so was gonna install them and have a light spray of water going against the rad, would that be any addition?

only way to bleed them is to jack the front up as far as you can.
the holes in the stat should solve your issues

[sideways-theonlyway]

95% sure fucking head gasket is gone, went out this evening, ran the car for bout twenty minutes to half hour at 2000 revs, whole system got pressurised, heat shot up to 3/4 mark, turned car off and you could hear the pressure hissing out of the rad and it was bulging! Also white smoke from exhaust...SHIT!

anybody want my place in tynagh on Sunday, pm me

[sideways-theonlyway]

anyone any recommendations on a replacement engine?
Best place to look?
Would it be much of a job to fit an m3 engine if I got my hands on one?
would I need the m3 gear box aswell or would the 328 one fit?

[conor]

as far as i know the m3 and 328i share the same zf gearbox

[sideways-theonlyway]

Finally I got an engine

Not only did I get an engine, I also picked up M50 manifold, BBTD, e30 flywheel, clutch and starter



When i was waiting to get an engine I done a bit more stripping.

More wiring gone, prick of a job



Boot floor and doors cut out, all glass gone also, should have polycarbonate in soon.











Front stripped to put in new engine





So gonna get the m20 flywheel lightened and get this back up and running with a new aluminium rad and fan. Can't wait

[Paddy drifter]

can i have some of that turf

shes coming along well , was there much weight in the boot floor

[arronmoloney]

Finally I got an engine

Not only did I get an engine, I also picked up M50 manifold, BBTD, e30 flywheel, clutch and starter



When i was waiting to get an engine I done a bit more stripping.

More wiring gone, prick of a job



Boot floor and doors cut out, all glass gone also, should have polycarbonate in soon.











Front stripped to put in new engine





So gonna get the m20 flywheel lightened and get this back up and running with a new aluminium rad and fan. Can't wait

Where did u pick up the m50 intake manifold and BBTB I can't find them any were ?