My 2012 Kouki S14a Rb25det Conversion

[longisland]

Hey,
well the turbo is made by highest quality.
Was tested by a lot of people in Australia.
Great results were achieved by them.
The supporting stuff like hoses lines and flanges are quality wise like HKS Tomei and so on.

Stuff is really worth the money!
Machined with Garrett/Mitsubishi machines and plans.


Just had not that much time to get on with the car.
Engine is out off the R33 and the break master cylinder went into the s-chassis.
Need to get a few ore stuff to get on with the project.

Georg

[slithertooth]

Welcome georg , looks like a great build , used those turbos on sr20's before with great success, looking forward to seeing it being used on your rb25, wouldn't mind doing something similar on my R32. good base car to start off with, wanted that myself but funds didn't allow

[longisland]

Hey folks,

here is a bit of an update.
Just got the engine in. Syko Performance Mount kit is great but I think I need to get another Master Clutch Cylinder. It sits really near to the intake manifold at least only 5mm space

Managed to get a R32GTR Goki 60mm radiator to go with the car.
Needed to space down the lower braces where the radiator sits on.
Its not to high and will clear the bonnet now, hopefully
Put in the oil cooler and shortened the lines. IC is mounted in too. But perhaps Ill rotate it 180° to have the in/outlet upperside to shorten the IC piping.

The manifold is great and Ive plenty of room for a bigger turbo sometime.
The turbo looks so sweet and tiny in this engineroom. haha.
should do its work.


My td06sl2-25g
60.5/78 AR60 Compressor
60/54.1 AR73 Turbine

Gt3076r
57/76 AR60 Compressor
60/ ?? AR?? Turbine

So it should pull hard

Theres so much left to do on this fuckin project.

Here some pictures:




A lot of new stuff is waiting to go in this car.
E-fans, 2litre petrol swirl pot with a bosch044...and so on.

I think hopefully in 2-4 months the car should be ready,