R34 rb26 Conversion.....

[Clockworks]

Im hoping to start stripping on monday,,could i give you a quick pm when im at the wiring stage?

[nissan_doctor]

Im hoping to start stripping on monday,,could i give you a quick pm when im at the wiring stage?

No problem, any help you need just shout..

[Clockworks]

Just another quick question,the rb26 engine seams reasonably quite and runs and pulls well,what would be the basic requirements before it goes back into the R34,I was thinking basis service items(oils,plugs,filters etc)and head/turbo gaskets sets,is there anything else I should check/change while its out of the car?

[Clockworks]

thoughts anyone?

[ontherack]

Might be worth checking (replacing) the main, and big end bearings. ARP rod bolts.

[Clockworks]

Hi again,,Finally got the rb26 fitted and running,next on the agenda is getting the speedo,rev clock and water temp working,Iv been told the r34 and r33 speedos work differently(ps we used the r33 engine loom....),any advice would be greatly appreciated...