zenki s14

[decobyrne106]

Oh boy oh boy where do i start with this, it's been a very long time since this was updated so keep that in mind it might not be in order
From what i can gather it goes as follows
Since the last update ive got a cage in the car which i then painted white and put carbon strips on the door bars which came up a treat
I also fitted a Greddy Profec B boost controller all went smoothly with no hicups thank god. I also had to move my pillar gauges to the centre and i fitted a proper FIA cut off as the last one was a pain in the rowlers.
Heres a few pics




I also got the clutch replaced and a braided clutch line.
The problem with the car was the release bearing seized from heat, twisted off the clutch fork and had no clutch, in the mean time the release bearing was spinning doing it's own thing and broke a collar off a plate just inside the bell housing.



luckily enough after a bit of contacting i got a replacement part from jay rockett at DI Motorsport and i also got a rear section of a prop with a good carrier bearing as mine was fairly shot so big thanks to him!
While the cage was being fitted and most of bits were takin out i rotated my cylinder on the hydro as it wore my big elbows a fair bit

I fitted some Ebc yellow stuff pads and some rear anti roll bar mount bushes from superpro.
I painted my rocker cover the same as my blue 17'' wheels and is rocking a autolifers sticker to set it off a bit (see what i did there)