Streeto R32

[Tomas_s13]

finaly liner!!!! if you still need them skinny bolts by monday give me a shout- will get you a set

[Dori_Rory]

Seen this in person yesterday, tidy lookin lump of a car! Best of luck with it Rory.

.....
.....
Rory

[slithertooth]

Cheers Tom and Roey, update time , addressed the interior firstly by swapping front seats to R33 series 2 ones and fitted a deep dish steering wheel , makes driving position much better but i'll keep on the lookout for s15/r34 seats for it


next up was to figure out what immediate stuff needed doing, steering rack is shot and turbo is blowing to a point of no boost, so engines coming out for a tidy up (nothing internal- yet.....) and hicas is getting binned.
Few bits to be done this week
RB25 turbo and elbow
ex mani studs replaced
engine leaks sorted
timing belt/service
a/c removal
replace steering rack wth R33 one
R33 LCA's
S13 rear subframe + solid bushes
Shim diff

Engine shot pre removal

[Micko]

Sweet car Rory, body looks mint.

Pretty sure its lynskeys old r32 from Navan, he used to work in Trevor Mconnells, minded it like a baby best of luck with her.

[slithertooth]

Sweet car Rory, body looks mint.

Pretty sure its lynskeys old r32 from Navan, he used to work in Trevor Mconnells, minded it like a baby best of luck with her.

Thats the one indeed , have a picture of it outside the church in dunboyne the day of my wedding, couldn't help going for it it's a pretty good base so hopefully i can make a good road car out of it

Thanks for all the comments lads , hopefully stuck into it this week

[slithertooth]

Bit of an update, so rear subframe got binned for a s13 one and in went solid bushes, and a couple poly bushes replaced the hicas joints.



Front rack was removed and replaced with r33 rack, p/s pump and crank pulley, also put in lca's out of r33 that were strenghtened and had a bit of bump stop work done



Engine got a clean up mainly new exhaust studs, gaskets, turbo gaskets, RB25 turbo / compressor elbow / turbo elbow

Inside got a dishy steering wheel and a Trust knobby

All fluids were changed and new rubber fitted to a set of rattle canned s14
wheels, running great now and every roundabout is an adventure

[pole drift]

Looking good, glad to see the subframe went to good use