Re drilling 4 stud wheels?

[PeterT]

Howdy folks, I have some decent sized ssr professors off my cefiro that are 4 stud. Si suggested taking them to an engineering shop and asking could they re drill them like you see on multifit wheels??

Can anyone think of any possible reasons why it wouldn't work?!

Would be nice onthe 14a

[colm]

The wheels would have been forged with the 4stud pattern so designed to take the load of the car that way.
There mightnt be metal in the right places for the new holes
Drilling new holes and keeping the whole thing concetric would be a pain in the balls
Getting 5 holes on the same pcd where there already are 4holes prob wouldn't leave much room and could end up breaking through each other.

Get some 4-5stud spacers instead

[Deco84]

swap hubs off the 14 with the cefiro jobs oxo

[PeterT]

Ah, yeh good point about the metal thing. Forgot they look weird when u look at the back of them.

Anyone make 5 to 4 stud conversion spacers?! Haha

[git]

Ah, yeh good point about the metal thing. Forgot they look weird when u look at the back of them.

Anyone make 5 to 4 stud conversion spacers?! Haha

i actually think ya can get these !

[200sx]

Ah, yeh good point about the metal thing. Forgot they look weird when u look at the back of them.

Anyone make 5 to 4 stud conversion spacers?! Haha

Theres a set on hear for sale.The lad thats building that yellow 180 has tread up hear,Young lad he had some for sale!

[twailbait]

Pcd adaptors are yout best bet, redrillIng isn't cheap.

Although the adaptors are going to be min 15/20mm thick, so will the wheels still fit?

Do a 4 stud conversion!!