it started out wit my r32 running rb25 running gear which unfornately ended up on its roof in stones drifting one sunday
after we were going to reshell all the running gear into a e30 bmw but wit the amount of fab tat was going to be required and two other cars to be built as well we decided just to go down the tried and tested 180 route wit rb25 running powers
spec of the running gear to be fitted
stantard block and head rb25
head oil drain kit
rb25 gearbox
custom apexi rx6 manifold wit 50mm external wastegate
greddy style inlet manifold
top mount fuel rail
evo 6 560cc injectors
split fire coilpacks
z32 airflow meter
power fc
bosch 044 fuel pump
sard fuel pressure regulator
alloy rad
custom front mount intercooler
oil cooler and relocation kit
electric fans
choice of turbos stantard steel wheeled rb25 one or hks 2530
4.3 final drive wit two way diff
as the skyline was per accident
the new shell tat i collected off nick180 sx on here
afaik the car was previsously run in prodrift as its seam welded etc and was never vrt,d
as i dont have much drifting experience im not going to bother doing much fab work on tis just enough to get it out and start drifting and wall tagging again
but most of all in tis build ill be going for relaibilty so it,ll be getting a custom mod docs wiring loom leaving just enough to run the bare estinals lights fuel pump and engine
suspension bits in tis is going to be
rear
tein rear coilovers
locking collars
all driftworks rear arms
rb25 rear hubs brakes and half shafts
front
s14 custom hubs wit skyline discs and pads
custom rb25 subframe
custom tie rods and ends
tein tension rods
will get more pics after work is started but hoping to get the inside and under the bonnet sprayed wit in two weeks and start to bolt bits on














Reply With Quote


