i need lock yo,

[Johnie]

If you just have std lock, why don't you try just putting in some washers on the steering rack? I have standard hubs with washers on my car and they make a huge difference. The biggest problem is the steering going over center though, so moving the rack forward or buying offset rack spacers is a must if you want to use all that extra lock without any unwanted dramas.
I don't have any mods to stop my steering going over center and it is annoying, but I will be moving my rack forward before I go drifting again as it is a pain when the car gets stuck on full lock.

[jamie180sx]

hve the tierod machined same thing really,,but just want more,,its not totally stock but its still cat really compared to the lock available

[Johnie]

Ok, does your steering go over center? I was going to buy the Driftworks hubs because they have the roll centre correction, but they do seem expensive and my car isn't very powerful, so I am a little concerned about putting them on the back too.

[chrisb]

we are running superclarky hubs...that is

me
duane
simon muldrew
michael (richhill tyre man)
mark mcconal
rob did run them in his 180

all down to settup of front suspension too but i can give you the rundown on that as well

i can make you, hubs, subframe with rack moved forward, and modified steering arms. some slight alterations need to be made to bottom arm and traction arm but is simple enough

[chrisbrady325]

we are running superclarky hubs...that is

me
duane
simon muldrew
michael (richhill tyre man)
mark mcconal
rob did run them in his 180

all down to settup of front suspension too but i can give you the rundown on that as well

i can make you, hubs, subframe with rack moved forward, and modified steering arms. some slight alterations need to be made to bottom arm and traction arm but is simple enough

This is the job jamie.. ive seen it myself, serious lock!!!