took her for a drive to the offie just now i also took pics of the readings and were there plumed into. uploading to photobucket at the moment, so they'll be up in awhile.

will have to go and get a 12volt wire tester 2morrow i say, strip down the dash again and find a better spot for the power.

@hoopsbhoy-it went smoothly enough for a first timer i thinks

the readings act seemed fine wen on full boost, both read the same at +0.5 bar (thats when i get my missfire). only the fact that i went and played around with the boost controller did i realizer that the readings it gives on idle isn't in bar but mmHg.