fitting hydro ?

[gem-s13]

Grand now i get the picture i went from a diagram found on net which was wrong now... ill do it this way so, as for the leak looked at the rest and there all correct just seems to be too short cause goes right up to the cylinder and gets tight and still leaks , as if its not sealing the inside,...


Cheers all for replys aswell

on most handbrake cylinders the nipple for sealing is way to far down in the hole best thing to do is get a copper washer and have it seal against the top of the cylinder,

[rowaner2002]

Not at all, glad to help in any way poss. Where is it leaking lad the handbrake or reservoir?? I still hav'nt fired up the car and bled the system coz im doin other bits to. hope dont have same probs cheers and thanks in advance

grand it was leaking at the rear hole in reservoir sorted it there other day tho got reservoir hole redone not as deep so it would lock all way up on the inside

on most handbrake cylinders the nipple for sealing is way to far down in the hole best thing to do is get a copper washer and have it seal against the top of the cylinder,

grand gem thanks for that only noticed your reply there got it fixed the other day cheers anyways