Extra Lock Q? How much

[si_berry]

ya the washers are a good job and cheap way to do it but then ya run into more problems like over center.which can be a pain in the hole

PS if you do go with it.keep an eye on the the thread left on the tie rod going back into the rack.can be left with very little thread and will be dangerous.could end crashing it over cutting cost

Might go with 2/3 washers and locktite the rod going into the rack then

[S13..KEV]

Might go with 2/3 washers and locktite the rod going into the rack then

job done dude.first few runs in it.just keep an eye on it to be safe.my advice would be save up on but the just jap extra lock kit or seamie's kit.end all youre worrys

[B&G Extreme Drifting]

job done dude.first few runs in it.just keep an eye on it to be safe.my advice would be save up on but the just jap extra lock kit or seamie's kit.end all youre worrys

jaysus kev hope that doesnt happen me
yea lad thread lock aswel thats exactly what i done....dont worry bout 235s have them on front also ya need ur grip at end of day...
kev u have me freaked now haha....into the wall down the straight of mondello

[Boguey001]

Just when we are on topic is there any difference between just jap's hubs and seamie's ones??

[si_berry]

Just when we are on topic is there any difference between just jap's hubs and seamie's ones??

Ring them both up, let me know who's the better sales man :

[kevs15]

Just when we are on topic is there any difference between just jap's hubs and seamie's ones??

think just japs include a modified subframe where shemies dosnt, but in my opion a modified subframe will gane ya feck all more..

[Stevo]

Justjap extra lock kit job done

[nick180sx]

think just japs include a modified subframe where shemies dosnt, but in my opion a modified subframe will gane ya feck all more..

moving the rack forward is a necessity otherwise youll be going over centre the whole time and modifying the hubs would be a pure waste of time,thats with just japs anyway don't know if seamies design overcomes this problem

[damo1]

u can get the driftworks offset rack spacers insted of modding the subframe also,..

when some lads are mad for getting more lock etc, and they have standard enough cars do they not realise they nead to get the rest of the car set up (e.g) the rear so that when the car is on full lock it has the grip and the power to pull itself out of the drift..

[Cooldrft]

moving the rack forward is a necessity otherwise youll be going over centre the whole time and modifying the hubs would be a pure waste of time,thats with just japs anyway don't know if seamies design overcomes this problem

You dont need to modify the subframe or use offset spacers with seamie's hubs.
I had offset spacers + took them off with I fitted his hubs.
No way will it go over centre